I have tried of and on for several days to attach the red and blue wire. I found this site and the hints sheet and have been trying to attach them to the right place at the end of the wire hanging down from the lamp. I have tried both ends of each lead without success. I am playing on a 23 inch i-mac and the game has been adjusted to fit the screen. It appears that the curser doesn't take the game piece down far enough to connect and it has disappeared off of the lower edge of the screen as it gets the piece as low as possible.
My next step was to take the game off of full screen. This helped. I could connect the 1st wire, but when I got the wire low enough to attach it and clicked, the curser was out of the bottom of the game screen and although that connected the piece, it selected the portion of the screen that did not have the game. When I went back and clicked on the game, the wire was no longer connected, so I have been able to make no progress.
The problem seems to be how low the curser "Grabs" the wire to attach it and that is assigned by the game and can't be adjusted.
I am stuck here unless anyone has an idea.
Thank you.
Send a KudoPost a Reply
Thomas Edison Clean and Fix, Kid 17 Search
Report as InappropriatePosted on 07/02/08, 12:14pm
I have tried of and on for several days to attach the red and blue wire. I found this site and the hints sheet and have been trying to attach them to the right place at the end of the wire hanging down from the lamp. I have tried both ends of each lead without success. I am playing on a 23 inch i-mac and the game has been adjusted to fit the screen. It appears that the curser doesn't take the game piece down far enough to connect and it has disappeared off of the lower edge of the screen as it gets the piece as low as possible. My next step was to take the game off of full screen. This helped. I could connect the 1st wire, but when I got the wire low enough to attach it and clicked, the curser was out of the bottom of the game screen and although that connected the piece, it selected the portion of the screen that did not have the game. When I went back and clicked on the game, the wire was no longer connected, so I have been able to make no progress. The problem seems to be how low the curser "Grabs" the wire to attach it and that is assigned by the game and can't be adjusted. I am stuck here unless anyone has an idea. Thank you. Send a Kudo Post a Reply